88 YJ-CJ Floor Repair Part 2

The floor patch continues...

Cut to size and clamped in place:

Lots of tack welds...

Lots of grinding of tack welds

A support channel under the floor was also cut by the previous owner

My Harbor Freight brake could not handle the geometry of the channel, so I had to improvise:

Channel shape finished:

Failed channel attempts!  It was an iterative process to find a way to form the channel with the correct dimensions.  I just used small scrap pieces until I found a good process (and good dimensions) to form the channel.

I also made a couple of overlapping reinforcement channels.  I haven't decided if I will use them or not:

Channel test fit:

Channel welded into place on one side.  The rear axle pumpkin was causing clearance issues, so I'll finish welding when I pull the axle to do other work.